Andrews Amplification Spectraverb Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Amplificador para instrumentos musicales Andrews Amplification Spectraverb. Andrews Amplification Spectraverb 13 páginas.

Imprimir página

Front Panel

1. INPUT JACKS –

(labeled HI and LO). The HI jack provides a bit more drive and sensitivity. The LO

jack provides a slight (6dB) attenuation and is useful when a cleaner and slightly

darker tone is desired, especially with high output pickups.

2. VOLUME CONTROL

amp. Try using the other input jack to widen the range of the Volume control

3. BRIGHT (BRT) SWITCH –

of brightness (treble) when playing at lower volume settings. The "up" position will

produce a bit more sparkle and treble articulation.

4. TREBLE CONTROL -

5. MID CONTROL

setting low for vintage American tones. Turn it up for a warmer tone or to add more

midrange grind at higher gain settings.

6. BASS CONTROL –

suggested to increase the bass setting as volume is decreased to compensate for

the way the human ear hears bass at different volume levels and to allow for

tighter high-volume usage. Bass is generally turned down at high volume settings

to keep the low end "tight". If playing at extremely high volume settings, the best

tone can be achieved but turning the Bass almost all the way down.

7. REVERB LIMITER CONTROL –

control is turned fully clockwise, the reverb functions as it would on classic amps

with spring reverb. This will provide maximum drive to the spring unit resulting in a

very thick, long lasting reverberation. As you play louder or drive the amp harder

with an external pedal, the reverb sound will increase. When playing cleaner or at

lower volume, the reverb level will be reduced because the reverb tank is not

driven as hard. When you adjust the reverb level get the perfect reverb setting for

clean tones, you may find the reverb too strong when you turn up for a solo. This

can be annoying when playing dynamically. This is why we have added our

exclusive Limiter control. When the reverb LIMIT is turned fully counterclockwise,

the reverb is limited so that there will be very little increase in reverb when your

volume is increased. The range of settings in between "0" and "10" allow for

varying degrees of limiting. Use in conjunction with the reverb MIX control (see

For maximum versatility, we have provided two input jacks

– Use this control to adjust the volume and gain of the

This switch is used to slightly increase the balance

This control varies the amount of treble.

– The Midrange control adjusts the midrange level. Keep the

This control varies the amount of bass. In general, it is

An Andrews Exclusive! When the LIMIT