Atlas Sound Masking Module AA-SMG Instrucciones de instalación - Página 2

Navegue en línea o descargue pdf Instrucciones de instalación para Amplificador Atlas Sound Masking Module AA-SMG. Atlas Sound Masking Module AA-SMG 4 páginas. Atlas sound sound masking module installation instruction

Imprimir página
AA-SMG
SOUND MASKING MODULE
1
2
4
3
TIP=SND
RNG-REC
SLV=GND
SET UP - PRIOR TO INSTALLING THE AA-SMG MODULE,YOU MUST DECIDE THE FOLLOWING.
1. Select White or Pink Noise (jumper J6)
2. Select Amp Direct or Mix Bus operation (jumper J7).
3. Turn the module gain pot down counter clockwise (Left direction).
4. Turn EQ pot clockwise (Right direction).
5. Turn the AA120M power switch off.
6. Carefully inset the AA-SMG module into the card guider rails. Push until card is seated and the panels
are flush. Secure with screws.
7. Select the AA120M input module mode, switch #5 located on the rear panel of the amp.
8.
Turn all levels down on amplifier. Note if the module is in Amp Direct mode, the only level control you
have for masking is the Gain pot on the AA-SMG. The Master and Input 6 levels on the AA120M are
bypassed. All other channels operate normally.
9. Turn the amp on. You should be hearing either White or Pink noise.
10. Whenever connecting the Line Out or Insert jack, always turn off the AA120M prior to connection.
11. Tune the system as needed. Always a good suggestion to refer to Atlas's white paper on masking.
(GND)
TIP
(HOT)
1601 JACK MCKAY BOULEVARD ENNIS, TEXAS 75119 U.S.A. •
©2007 ATLAS SOUND LP
GAIN
EQ
LINE OUT
EQ INSERT
TIP
SLEEVE
(SEND)
(GND)
RING
(REC)
CONNECT TO
AA-SMG
Specifications are subject to change without notice
AtlasSound.com
Printed in U.S.A.

INSTALLATION INSTRUCTIONS

8
5
OUT TO AMP
OFF
J8
ON
PRE EQ
POST EQ
LINE OUT
AMP DIRECT
MIX BUS
TELEPHONE: (800) 876-3333 • FAX: (800) 765-3435
ATS002745 RevA 3/07
7
6
SLEEVE
TIP
(SEND)
(GND)
SEND - CONNECT
TO EQ IN
SLEEVE
TIP
(GND)
(REC)
RECEIVE - CONNECT
TO EQ OUT
2