Atlas Copco 8433327030 Instrucciones del producto - Página 12
Navegue en línea o descargue pdf Instrucciones del producto para Herramienta eléctrica Atlas Copco 8433327030. Atlas Copco 8433327030 20 páginas. Battery-powered nutrunner
Imprimir página
Operation
The table below provides an overview of the standard flash patterns.
LED indicator
All indicators
Battery level
Battery level
Alarm
Alarm
Radio connection
Radio connection
Tightening direction
Tightening direction
Tightening direction
Tightening
As tightening torque increase the reaction force build up equally. Make sure that the tool is in correct work-
ing order and that the controller is correctly programmed. By doing this you avoid unexpected behavior
from the tool, which may result in operator injury.
Rotation Direction for the Tightening
Check that the tool is in the correct running direction by turning the reverse button or reverse ring :
Pistol Grip Models (with side buttons)
■
Press in the reverse switch on the right hand side of the tool, to set the direction clockwise (CW).
■
Press in the reverse switch on the left hand side of the tool, to set the direction counter clockwise
(CCW).
Pistol Grip Models (without side buttons)
■
Double press the function button on the top of the start trigger to shift the direction between clockwise
(CW) and counter clockwise (CCW).
Angle Models
■
Turn the reverse ring to the right, to set the direction clockwise (CW).
■
Turn the reverse ring to the left, to set the direction counter clockwise (CCW).
Soft Start
The soft start function facilitates the screwhead and thread to reach the snug level. The duration of the
soft start is adjustable.
For further information about tightening, see Power Focus 6000 Configuration manual.
12
EN
Light behavior
All flashing
All flashing white: high frequency
flashes
One flashing red
Flashing: one flash per second
Flashing: high frequency flashes
Blue
Flashing
Both directions flashing: high fre-
quency flashing, 3/s.
Both directions flashing: high fre-
quency flashes followed by steady
light.
Both direction flashing: low fre-
quency, 1/s.
© Atlas Copco Industrial Technique AB - 9839 0852 01
ETP SRB 31-20-10
Status
Tool has started.
Tool is running on the backup bat-
tery.
Battery is empty.
Invalid configuration of tool WLAN
settings in ToolsTalk Service 2.
Battery software outdated. It is not
allowed to operate the tool with bat-
teries running outdated software.
Radio connection established /
ToolsTalk Service 2 connection es-
tablished.
Start request not received in time
by the tool, due to bad connection.
Software update is ongoing (takes
up to 7 minutes).
Indicates one of the following:
■
Invalid data on SD-card
■
Error during tool software up-
date
■
SD card is missing
Tool is connected via USB cable
and is waiting for ToolsTalk Service
2 to connect.