Alert 550R LCD Manual del usuario - Página 9

Navegue en línea o descargue pdf Manual del usuario para Alarma de coche Alert 550R LCD. Alert 550R LCD 13 páginas.

Imprimir página

. Make sure the remote start system is not operating the engine.

. Turn the ignition on. The LED and parking light will flash (4) times. The horn chirps (4) times.

✱

. Press the

button twice to remote start the vehicle. As soon as the vehicle is running and

the parking light have turned on or flashing.

. Immediately depress the

button then press and hold the

parking light will flash (4) times. The siren or horn chirps (4) times. The vehicle is no longer

programmed to start automatically.

G. TEMPERATURE CHECK

You can monitor through the LCD screen, the present indoor temperature of the passenger

compartment before cooling or heating your vehicle.

Press the transceiver F button first, within seconds press the

temperature will be shown on the LCD screen. This reading may be higher than actual ambient

temperature due to the greenhouse and is relative only the inside vehicle temperature.

H. TO TURN OFF THE REMOTE START:

When the engine is running (by remote start), if you want to stop it,

. Press button twice on the remote transmitter under remote start mode.

. Move the optional remote start enable toggle switch to OFF position. (If installed)

. Press the brake pedal

4. Pull down the hand brake. (for Standard Transmission Gear Vehicle)

The vehicle will shut down and turn off the parking light to indicate engine stopped.

I. SHUT-DOWN INPUT FOR REMOTE STARTER:

If any of the following conditions exist while the system is operating, the engine will not start or

will shut down immediately:

✱

button for seconds. The

(·) button; the in-door

. The hood is opened.

. The brake pedal is pressed.

. The hand brake is released (for Standard Transmission Gear Vehicle)

4. Engine is over-revved. {"Tachometer checking type" only}

5. The pre-programmed run time (5 /0 / 0 / 0 minutes) has elapsed.

✱

6. Press

button twice on the remote transmitter under remote start mode .

7. Move the optional remote start enable toggle switch to OFF position. (If installed)

8. The vehicle refused to start running after {} unsuccessful attempts.

J. DISABLING THE REMOTE START SYSTEM: (If installed)

This feature allows your system's remote start unit to be temporarily disabled to prevent the

vehicle from being remote started accidentally. This feature is useful if the vehicle is being serviced

or stored in an enclosed area. To disable the remote start, move the optional remote start enable

toggle switch to the OFF position.

LCd rEmOTE TrANSCEIVEr

Note: If the system is interfered by

stronger radio frequency around, sources

of high voltage electric power or such

Obstacles like tall buildings and so on, the

transmission range may get shorter as the

system uses low output power frequency.