Bose 131 Manual del usuario - Página 7
Navegue en línea o descargue pdf Manual del usuario para Sistema de altavoces Bose 131. Bose 131 18 páginas. Marine loudspeaker system
También para Bose 131: Manual del usuario (37 páginas), Manual del usuario (23 páginas), Manual de servicio (7 páginas), Manual de servicio (7 páginas), Manual (7 páginas)
Imprimir página
Installation from the rear of the bulkhead
A
A 2
A 3
AM188201_02_V.pdf
Installing Your Speakers From The Rear Of The Bulkhead
Choose the 5
3
⁄
inch (13.6 cm) diameter hole size if you can comfortably hold the
8
speaker enclosure from behind the wall while installing screws from the front. This is
the preferred mounting method. If the hole you cut is not perfect, any slight overcut
will be hidden by the grille.
Determine that there is enough room by
A 1
reaching into the mounting area and
sweeping with your hand. Determine
where you will drill the hole for the
speaker. You should also experiment by
placing the speaker enclosure behind
the bulkhead before making your final
selection. Any orientation of the speaker
enclosure is acceptable.
CAUTION: Determine whether any
obstacles exist behind the mounting
surface. To be certain, contact your boat
manufacturer or dealer. Also, be certain
that the enclosure will fit within the mount-
ing area before drilling any holes.
The round outer edge of the template
shows how much room to allow for
the grille. The long end is used to plan
for room for the enclosure behind the
bulkhead. There are two perforated
circles in the template. Snap out the
smaller one.
Place the template over the area
where the speaker is to be located
and mark the 5
3
⁄
inch (13.6 cm)
8
hole with a metal scribing tool or
pencil.
Drill a starter hole that is large enough
A 4
for your sabre saw blade. Be sure to
drill inside and close to the line you
have marked.
October 30, 2001
7