Atlas fan company Irene YG432-MG Manual de instalación y uso - Página 6
Navegue en línea o descargue pdf Manual de instalación y uso para Ventilador Atlas fan company Irene YG432-MG. Atlas fan company Irene YG432-MG 12 páginas. 52" ceiling fan
Imprimir página
5. Loosen the two set screws and remove the
hitch pin and lock pin from the central
shaft/top coupling of the motor assembly.
Doing so will allow the down rod to enter
the central shaft. (Fig.9)
6. Carefully feed the fan wires through the
down rod and pull them taught. Place the
down rod into the central shaft and tighten
with the lock pin and hitch pin previously
removed, re-tighten the set screws against
the downrod.
7. Slide the coupling cover (with wide end
oriented to the floor) down the down rod.
8. Slide down the secure ring, and fasten
using the Allen wrench provided.
9. Slide canopy cover (with decorative side
oriented to the floor) and canopy (with wide
end oriented to the ceiling) onto the down
rod. Carefully reinstall the hanger ball onto
the rod. Be sure that the cross pin is in the
correct position, the set screw on the
hanger ball is tight and that the wires are
not twisted.
10. Now lift the motor assembly (fan with
blades) into position and place the hanger
ball into the hanger bracket. Rotate the
down rod until the "Check Tab" has dropped
into the "Registration Slot" and the down
rod and ball assembly seat firmly. The down
rod and ball assembly should not rotate if
this is done correctly. (Fig.10)
4