Beckmann Egle MT 20x2 Manual - Página 16

Navegue en línea o descargue pdf Manual para Unidad de control Beckmann Egle MT 20x2. Beckmann Egle MT 20x2 20 páginas.

Imprimir página

MT 20x2/40x2

Fixed texts

•

ESC

The MiniTerminal outputs all stored fixed texts in sequence via the serial interface. Each fixed text is

terminated by 'CHR$(0)'. Transfer is terminated by entering 'CHR$(0)' twice (See Memory Format

under 'Load Fixed Text').

Example:

PRINT #1,CHR$(27);"W";

ESC

The MiniTerminal returns every character after entry. If an error is found during entry (for example,

EEPROM is defect or memory is full), the character is inverted. As it is not possible to transmit and

receive simultaneously, you must wait for the character returned by MiniTerminal to appear before

sending the next one.

Saving the text to memory takes approx. 1 second per 100 characters.

Example:

PRINT #1,CHR$(27);"R";

PRINT #1,"T";

INPUT$(1,#1)

PRINT #1,CHR$(0);

PRINT #1,"K";

INPUT$(1,#1)

PRINT #1,CHR$(0);

Warning: All fixed texts stored in EEPROM are overwritten during transfer.

Recommended methods for changing or extending existing fixed texts:

Read existing fixed texts with 'ESC W' command and save in file (1 fixed text per line)

Edit fixed text with ASCII editor (note format for EEPROM).

Read fixed texts from file with 'ESC R' command and save in EEPROM

-> The MiniTerminal test program featured in the Software chapter contains these functions.

EEPROM storage format:

´FT0´+Chr$(0)+ ´FT1´+Chr$(0)+ ´FT2´+Chr$(0) ........ ´FTn´+Chr$(0)+Chr$(0)

Festtext ausgeben :

Fixed texts are numbered from 0 to 127.

The display is cleared before fixed text is output.

Fixed texts may contain the special character CR.

....

Output fixed texts via serial interface

Save fixed texts in EEPROM

character ("T") of the 1

wait until the character is returned

End of the 1

fixed text

character ("K") of the 2

wait until the character is returned

End of the n

fixed text

End of entry

Page 16

fixed text

Internet: www.bue.de