Anova D6013COM Instrucciones de montaje - Página 2
Navegue en línea o descargue pdf Instrucciones de montaje para Mobiliario exterior Anova D6013COM. Anova D6013COM 2 páginas.
Imprimir página
3. Place one of the Table Legs next to the tabletop frame
support as shown. When viewing down the frame
support from the outside of the table, the Leg should go
on the right side of the frame support. Put a Washer on
one of the 1.25" long Bolts and insert the Bolt through
the Leg and frame support with the bolt head toward
the outside of the Tabletop. Install a Washer and Nut to
the Bolt and hand tighten, leaving the Nut finger-tight.
Repeat this step for each of the three remaining Legs.
4. After all the Legs are attached (only two are shown
here for clarity), install the Cross Brace. Put a
Washer on one of the 2.25" long Bolts and insert
the Bolt through the Leg and Cross Brace with
the bolt head toward the outside of the Tabletop.
Install a Washer and Nut to the Bolt and hand
tighten, leaving the Nut finger-tight. Repeat this
step for each of the three remaining Legs.
5. Use a Rubber Mallet or Hammer to seat the
Plastisol Plugs into the holes on the bottom of
each Leg.
6. Position a Seat upside-down next to one of the Legs as shown. The leg brackets attach to the
outside of each of the seat frame cross-members. Put a Washer on one of the 1.25" long Bolts
and insert the Bolt through the leg bracket and seat frame cross-member with the bolt head
toward the outside of the Seat. Install a Washer and Nut to the Bolt and hand tighten, leaving
the Nut finger-tight. Repeat this step for each of
the three remaining mounting holes in that Seat.
Install the three remaining Seats in the same
manner.
7. Turn the table right side up and tighten the table
frame hardware while checking with a Level;
minor adjustments can be made while tightening
the hardware to make the Tabletop level.
8. Tighten the hardware on each of the seat frames
while checking the Seat with a Level; minor
adjustments can be made while tightening the
hardware to make the Seat level.
9. Retighten all hardware two weeks after initial
assembly.
•
Furniture must not be used other than for its intended purpose and should be inspected regularly for loose,
missing, or broken hardware, and general instability.
•
Furniture that is damaged or appears to be unstable must be removed from service and be repaired or replaced.
wArnInG
•
Repairs must be made using only factory authorized parts and methods.
cAre AnD
•
Do not drag the assembled unit across any surface.
mAIntenAnce
•
This product requires only periodic cleaning with a sponge and a solution of mild detergent and water to
remove surface dirt. Do not clean with a solvent or petroleum based products.
211 No
St. Louis, MO 63141
rth Lindbergh Blvd.
Washer
Tabletop
Frame
Insert
Plugs
Washer
tel: 888.535.5005
web: anovafurnishings.com
Leg
Washer
Nut
Bolt
Leg
Washer
Nut
Cross
Bolt
Brace
Leg
Leg
Bracket
Washer
Washer
Nut
Bolt
Seat Frame
11/2012