ANSMANN ATPS 2324 Manual de instrucciones - Página 4

Navegue en línea o descargue pdf Manual de instrucciones para Fuente de alimentación ANSMANN ATPS 2324. ANSMANN ATPS 2324 16 páginas.

OPERATING INSTRUCTIONS

USE OF THE POWER SUPPLY

The power supply have output voltages in 6 steps (3.0V; 4.5V; 6.0V;7.5V;9.0V;12.0V). A universal

range of output plugs and a polarity inverter allows to use the power supply for a lot of electrical

equipment like walkman, radio, CD-player, electrical toys etc. without using batteries.

Read this instruction manual carefully before use!

IMPORTANT ADJUSTMENTS BEFORE USE

1. Check current (mA)

The current (mA) rating of the power supply must be the same or more than that required for the

equipment to be powered (see table no 1). The current will be shown on the equipment or in it´s

instruction manual.

2. Choose the correct connector

The enclosed connectors correspond to the most commonly used. The correct connector should ﬁt

properly using a little pressure. Do not use extreme force to set the connector as this could damage

the unit to be powered.

3. Set the correct polarity for the equipment to be powered

Look on the equipment or its intruction manual for the polarity and set the coupling socket (3) to the

correct polarity (see drawing no. 4)

4. Set voltage for the equipment

Check the voltage (V) required for the equipment and set the selector switch (2) on the base of the

power supply with the arrow pointing at the appropriate voltage. If the voltage is not known start with

the lowest voltage (3.0 V). If the equipment do not work in this position take the next voltage position

until the equipment works.

ATTENTION

The power supply are for indoor use only.

The power supply should be disconnected from the mains when not in use. Do not plug in the power

supply in case of damaged cabinet or power plug. Never open the power supply.