AIRTUG TT-HD-EM-8 Instrucciones de montaje y uso - Página 3

Navegue en línea o descargue pdf Instrucciones de montaje y uso para Maquinaria agrícola AIRTUG TT-HD-EM-8. AIRTUG TT-HD-EM-8 5 páginas. Trailer tugs

Battery Maintenance:

1. New batteries require a full charge before use and need to be cycled several times before

reaching full capacity.

2. Battery connections should be kept tight at all times. Periodic inspection is recommended.

3. Keep batteries clean from all dirt and corrosion.

4. Batteries should not be discharged to the point of no longer being able to power the tug. Keeping

the batteries fully charged will greatly reduce the risk of a dead battery when you need it most.

5. Batteries should be brought up to a full charge at the earliest opportunity using the built in 24V

battery charger with reverse polarity protection and ﬂoat mode. The battery charger should be left

ON when the tug is parked to maintain proper charging and maintenance of batteries at all times.

Keeping the batteries fully charged will reduce the risk of freezing in cold temperatures.

6. Avoid charging the batteries when the ambient temperature exceeds 120

7. Older batteries will take longer to fully charge.

8. Periodic battery testing is an important preventative maintenance procedure. Voltage tests (open

circuit, charged or discharged) can identify a bad or weak battery. Load testing will identify a bad

battery when other methods fail. A weak battery will cause premature failure of a companion

battery.

9. Extreme temperatures can substantially affect battery performance and charging. Cold

temperatures reduce battery capacity and retard charging.

CAUTION:

Read, study and understand all warnings and operating instructions prior to use.

* When working on the tug:

* Put the tug up on blocks to get the drive wheels off the ground before beginning any work.

* Do not allow anyone to stand directly in front of or behind the vehicle during testing.

* Make sure the Power switch is off.

* Use well-insulated tools.

* RUNAWAYS - Some conditions could cause the tug to run out of control. Disconnect the motor, or

jack up the tug, and get the drive wheels off the ground before attempting any work on the motor

control circuitry.

* HIGH CURRENT ARCS - Electric vehicle batteries can supply very high power, and arcs can occur if

they are short circuit. Always turn off the battery circuit before working on the motor control circuit.

* Wear safety glasses, and use properly insulated tools to prevent short circuit.

* Do not overload this tug beyond the rated capacity.

* This tug is designed for use only on hard level surfaces capable of sustaining the load.

* No alterations to the tug shall be made.

* Electronic components may be damaged if exposed to water! This is not covered under warranty. 

* Failure to heed these warnings may result in personal injury and/or property damage.