ADDER AdderLink X100 Manual del usuario - Página 9
Navegue en línea o descargue pdf Manual del usuario para Extensor ADDER AdderLink X100. ADDER AdderLink X100 19 páginas. Extender set
También para ADDER AdderLink X100: Manual del usuario (19 páginas)
Imprimir página
Special configuration
Configuration
You can alter the way that the X100 receiver operates to suit your requirements.
This is done using the Configuration mode and you can affect the following
settings:
•
Password.setting
– allows you to lock the remote module to prevent
unauthorised system access.
Mouse.restoration.and.settings
•
and also to change the mouse type.
Video.compensation
•
- sharpness & brightness – allows you to manually
adjust the video image to ensure that it is crisp and bright.
Skew.adjustment
•
(X100AS only) – allows you to manually compensate for
possible video errors introduced by long, uneven cable connections.
•
Miscellaneous.settings
– report firmware version and restore settings.
What are hotkeys?
Hotkeys are two normal keyboard keys that, when pressed simultaneously with
a third key, signal to the local device and X100 receiver that you are sending a
message specifically to them and not to the computer. The hotkeys are ordinarily
and
, while a third keypress determines what you want the modules to
do.
If the standard
and
hotkeys are also needed for computer tasks, you
can change them for another combination using switches 2 and 3 on the X100
receiver:
2 OFF
3 OFF
Hotkeys =
and
2 OFF
3 ON
Hotkeys =
and
2 ON
3 OFF
Hotkeys =
and
2 ON
3 ON
Hotkeys disabled
– allows you to restore mouse operation
(default setting)
Entering, using and exiting configuration mode
To enter and use configuration mode:
1 Simultaneously press the currently configured
hotkeys (by default,
and
The three keyboard indicators ('Num Lock', 'Caps
Lock' and 'Scroll Lock') will now begin to flash in
sequence to show that you are in configuration
mode.
2 Press the first letter of the required configuration
option, for instance
.
All three keyboard indicators will illuminate
continuously.
3 Press the number of the required configuration
option, for instance
.
The 'Scroll Lock' indicator will extinguish, leaving
the 'Num Lock' and 'Caps Lock' indicators lit.
4 Press
to confirm your option.
The three keyboard indicators ('Num Lock', 'Caps
Lock' and 'Scroll Lock') will now begin to flash in
sequence again.
To exit from configuration mode:
1 Within configuration mode, the three keyboard indicators should be flashing
in sequence to show that the module is ready to receive a new command.
2 Press
.
The three indicators will return to their normal states.
) along with
.