Anywave PA-U-2200-D-FB Marble Manual de inicio rápido - Página 11

Navegue en línea o descargue pdf Manual de inicio rápido para Transmisor Anywave PA-U-2200-D-FB Marble. Anywave PA-U-2200-D-FB Marble 18 páginas.

If the PA FREQ does not match the Exciter TX FREQ, please be sure that the serial

cable is properly connected don each side. You can alternatively bypass the PA

AUTO detection of the Exciter channel FREQ by changing the PA FREQ-TYPE

from AUTO to MANUAL – which will cause a channel frequency pull-down menu

to appear – by which you would manually select the channel frequency that the

exciter is set to. If using the manual approach, please also double check that the PA

(mains STATUS screen) displays the same channel frequency as the Exciter before

proceeding further.

6) Turn the PA RF-Switch to ON on the System Settings tab.

7) The built-in FWD and REF power metering in your Marble PA has already been

calibrated at the factory. The PA's touchscreen and its Web interface both contain

the System Forward and Reflected power meter readings FWD-POW and REFL-

POW. Visit the PA's Web interface and verify that the currents (Cur1 thru 9 are

showing real values and not all 0s.

Mable 8Device Quick Start Guide, 5/19/2022

Marble 8Device Quick Start Guide

Page 11 of 18