Anywire ARW-03 Manual del producto - Página 14
Navegue en línea o descargue pdf Manual del producto para Unidad Blu-ray Anywire ARW-03. Anywire ARW-03 17 páginas. Address writer
También para Anywire ARW-03: Manual del producto (6 páginas)
Imprimir página[Writing of parameters]
This is the mode to enable renewal by turning on the transmission signals and power again.
Check that power (in the case of 2-wire type, transmission signal) is supplied to the target unit in writing addresses.
And after writing all the addresses, confirm the safety and reset the power (in the case of 2-wire type, transmission
signal) of the target unit to update the result of writing.
■Parameter writing operation
How to operate
1
Turn ON the POWER switch.
2
Press the SELECT switch.
Press the SELECT switch several
3
times to light the WRITE display.
4
Press the SET switch.
Press the UP switch once to change
5
the display to parameter writing.
6
Press the SET switch.
Display the parameter value to be
written by using the UP/DOWN switches.
Point the light emitting and receiving
part (yellow frame) at the address
setting port of the unit to be written
and then press the SET switch.
7
In the case of failure in writing
Readjust the light emitting and
8
receiving part and
press the SET switch again.
If writing parameters from another
9
unit, return back to Operation
No.6 to repeat the operations.
- Clear the Err display.
- Switch the mode to another mode.
10
Press the CLEAR switch.
11
Press the L switch.
If returning to the address setting mode,
12
press the DOWN switch once.
After using ARW-03, keep the POWER switch
pressed to turn OFF the power.
WRITE (yellow)
Example)
Example)
Example)
WRITE must be lighted.
-ARW03 14/17-
Display
After approximately
2 seconds, "SELECt" flashes.
Flashing
The writing mode is
determined.
Dot flashing movement
In the case of selecting
variable "1" in parameter 1
During the writing operation
Written parameter values
Err display
During the writing operation
Written parameter values
Return to the writing
mode display
Dot flashing movement
Change to the Ad display.
Light emitting and
receiving part
(yellow frame)