Aobosi CLS45 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Frigorífico Aobosi CLS45. Aobosi CLS45 13 páginas. Car refrigerator

Aobosi CLS45 Manual del usuario
8.TOUBLESHOOTING
Issues
Refrigerator does
not work
Refrigerator
compartments
are too warm
Food is frozen
"
water flow
There is
noise from inside the
refrigerator
There are waterdrops
around the refrigerator
casing or door gap
The compressor is
slightly noisy when
starting
Code F1 displayed
Code F2 displayed
Code F3 displayed
Code F4 displayed
Code F5 displayed
Code F6 displayed
Code F7 or F8 displayed
• Check if the switch is on.
• Check if the plug and socket are connected well.
• Check if the fuse has been burnt.
• Check if the power supply is malfunctioned.
• Switch on/off the fridge frequently may cause start delay of the compressor.
• The door is opened frequently.
• A large amount of warm or hot food was stored recently.
• The refrigerator has been disconnected for a long time.
• The temperature was set too low.
"
• It's a normal phenomenon, caused by the flow of refrigerant.
• It's a normal phenomenon, the moisture will condense to
water when it touches a cold surface of the refrigerator.
• It's a normal phenomenon, the noise will be reduced
after the compressor works stably.
• Possible cause: low voltage to fridge.
Adjust the battery protection from High to Medium or from Medium to Low.
• Possible cause: condenser fan is overloaded.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
• Possible cause: the compressor starts too frequently.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
• Possible cause: compressor not kicking in.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
• Possible cause: overheating of the compressor & electronics.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
• Possible cause: no parameter can be detected by the controller.
Disconnect power to fridge for 5 minutes & re-start.
If the code shows again, contact manufacturer for service.
• Possible cause: temperature sensor is faulty.
Contact manufacturer for service.
Cause/Suggestions