Aopos E120 Manual del usuario - Página 11

Navegue en línea o descargue pdf Manual del usuario para Lector de códigos de barras Aopos E120. Aopos E120 16 páginas. Thermal barcode printer

6 . Setting Up the Printer

Please unpack the printer package, and inspect the parts according to the packing list. If

any parts are missing or damaged, please contact the customer service of your purchased

reseller or distributor.

1） Make sure the printer power switch is OFF;

2）The printer power jack is a 3-pin socket and for 24V DC power input. Please plug

the DC cord connector into the printer's power jack properly.

CAUTION:

■ When connecting or disconnecting the plug, always hold the plug but not the cord.

■ Avoid pulling the power cord, otherwise any damages may cause a fire or

electrocution.

■ Avoid placing the power cord around other over heated equipment to prevent power

cord melting, which may cause a fire or electrocution.

■ We recommend that you unplug the printer from the power outlet if no use it for a

long period

1）Make sure the printer power switch is OFF.

2）Plug the data cable connector into the printer's interface properly.

3）Plug the other end of the data cable with the host computer.

CAUTION:

■ Please do not plug the data cable when the printer power is ON.

To install the sticker paper and label roll, please refer . Paper Roll Installation

7 、Power On Utilities

There are five power-on utilities to set up and test printer hardware. These utilities are

activated by pressing FEED button and PAUSE button.

7.1、 Self-Test

To start the printer self-test, please follow the below steps,

1. Turn off the printer power.

2. Make sure the paper roll is installed correctly and the printer top cover is closed.

3. Press the FEED button and turning on the printer power simultaneously. When the

self-test paper (chart 22) comes out, release the FEED button.

（

Thermal Barcode Printers

20）

24V DC