AudioPressBox APB-D116 R-D Manual del usuario - Página 5
Navegue en línea o descargue pdf Manual del usuario para Amplificador AudioPressBox APB-D116 R-D. AudioPressBox APB-D116 R-D 9 páginas. Press conference audio distribution amplifier
Imprimir páginaAPB-D116 R-D - Front panel (Input section)
1
Clip
Channel A
1) Input gain level knob
You can set the input signal level depending on the
connected audio source to reach the optimal output level.
You can check the output level on the Output level meter
(5).
If Dante input is selected you can adjust the level of Dante
signal.
2) Dante switch
You can switch between analogue or Dante input. When
the Dante input is selected the blue LED above the switch
is lit.
2
3
4
6
5
APB-D116 R-D
Gain
High Pass
Composer
Reduction dB
Filter
& Limiter
Output
Level dB
3) High Pass Filter switch
You can turn ON the HPF to eliminate low frequency
disturbances like pops or microphone handling noise. The
cut-off frequency of the HPF is 160Hz. It is very handy for
speech. If you need to distribute the music or full-range
signals it is handy to have the HPF switched off.
4) Compressor/Limiter switch
If you need to reduce the dynamics of the input signal
and/or be sure that the output signal will not be higher
than the nominal output level please switch this button
ON. Function of the compressor and limiter you can see
on the Gain reduction level meter (6). It is very good for
speech.
Mic
Line
Mic
Line
Mic
Line
1
2
3
On
Mic
Line
Mic
Line
Mic
Line
9
10
11
5
7
Mic
Line
Mic
Line
Mic
Line
Mic
4
5
6
Mic
Line
Mic
Line
Mic
Line
Mic
12
13
14
15
5) Output level meter
6) Gain reduction meter
7) Line/MIC Outputs
Individually transformer isolated outputs with switchable
Output level (Line / MIC). 3-Pin XLR balanced output
connector.
Line
Mic
Line
7
8
Line
Mic
Line
16