Aponorm Basis Control Manual de instrucciones - Página 12
Navegue en línea o descargue pdf Manual de instrucciones para Tensiómetro Aponorm Basis Control. Aponorm Basis Control 19 páginas.
Imprimir página1. Open the battery compartment
of the device.
2. Replace the batteries – ensure correct polarity
as shown by the symbols in the compartment.
3. To set date and time, follow the procedure
described in «Section 2.».
The memory retains all values although date
and time must be reset – the year number
therefore flashes automatically after the
batteries are replaced.
Which batteries and which procedure?
Use 4 new, long-life 1.5V, size AA alkaline
batteries. Use only batteries of one brand at
a time.
Do not use batteries beyond their date of
expiry.
Remove batteries if the device is not going to
be used for a prolonged period.
Using rechargeable batteries
You can also operate this device using rechargea-
ble batteries.
Only use «NiMH» type reusable batteries.
Batteries must be removed and recharged
when the flat battery symbol appears. They
aponorm
®
Basis Control
on the bottom
5
8. Using a Mains Adapter
You can operate this device using the aponorm
by microlife mains adapter (DC 6 V, 600 mA).
1. Plug the adapter cable into the mains adapter
2. Plug the adapter plug into the wall socket.
When the mains adapter is connected, no battery
current is consumed.
should not remain inside the device as they
may become damaged (total discharge as a
result of low use of the device, even when
switched off).
Always remove the rechargeable batteries if
you do not intend to use the device for a week
or more.
B atteries cannot be charged in the blood
pressure monitor. Recharge batteries in an
external charger and observe the information
regarding charging, care and durability.
Only use the aponorm
adapter available as an original accessory
appropriate for your supply voltage.
E nsure that neither the mains adapter or the
cable are damaged.
socket
in the blood pressure monitor.
4
®
by microlife mains
®
10