Dusty Strings Hammered Dulcimer Manual del usuario - Página 7

Navegue en línea o descargue pdf Manual del usuario para Instrumentos musicales Dusty Strings Hammered Dulcimer. Dusty Strings Hammered Dulcimer 18 páginas.
También para Dusty Strings Hammered Dulcimer: Manual del usuario (14 páginas)

Dusty Strings Hammered Dulcimer Manual del usuario
bend. Keep tension on the string as it wraps onto the pin, so that it forms tight
coils down and away from the small starting hole. Make sure the whole string is
sitting in its correct position and is not caught up on any other pins, strings, or bridge
pedestals.
e pin should rotate about three times before the string becomes taut.
Tune it slowly up to proper pitch.
becomes smooth with practice.
A new string will stretch a bit before stabilizing, so you may need to tune it a
few times in its fi rst hour of service.

Restringing the Whole Dulcimer

Depending on atmospheric conditions, a string set can last a long time, some-
times even years if there are no wound strings. Wound strings typically get dull-
sounding within a year or so and need periodic replacement (see String Types, page
3). It is really an issue of personal preference when (or if ) you replace the whole set
of strings on your instrument. If they get dark and corroded-looking, and seem to
have lost their "singing" quality, it may be time. You can go to your local dealer and
inquire about re-stringing, or dig into it yourself. It is really very straightforward,
though time-consuming.
e only important thing to know about this process is that it is best to take
off and replace only one course (two strings) at a time.
tension on the instrument, and you can get it back to holding pitch more quickly.
Also, you maintain bridge placement, which protects you from having to fi ddle
around with re-setting the treble bridge in its precise fi fth-interval tuning placement
(see Tuning Hints on page 12). You can follow the instructions above for how to
take off the old strings and put on the new ones.
If, however, you want to give the soundboard a thorough cleaning as well as
changing the strings, you may want to remove all the strings at once, as well as the
bridges. Make sure you carefully mark the placement of the bridges (we suggest using
tape for this purpose) before you remove all the strings.
and will need to be replaced exactly if the instrument is to be tunable. Before cleaning
the soundboard, please read the section below on your instrument's fi nish.
If you hear a raspy, buzzing sound when you play your instrument, a string is
probably resting too lightly on a side bridge so that it vibrates against the bridge
when it is struck. If you suspect that this is happening with one of your strings,
press down on the string right next to the tuning pin and strike the string. If the
buzz is gone, you've found the culprit, and you can permanently silence it by
lowering the string so that it makes solid contact with the side bridge. Do this by
loosening the tuning pin about half turn while pushing the string down toward the
pinblock. Hold this position as you re-tighten the tuning pin.
may apply to string buzzes on the hitch pin side. In the case of some of the higher,
right-side bass bridge strings, the opposite solution may be required: you might fi nd
places where it seems easier to raise the string on the tuning pin and completely
eliminate contact with the side bridge.
to the right of the bass bridge are not used for playing.
4
e whole process will seem awkward at fi rst, but

String Buzzes

is works only because the string sections
is allows you to maintain
e bridges are not glued down
is same remedy