AUSTRALIAN MADE GREAT MATE Instrucciones de instalación y configuración - Página 7

Navegue en línea o descargue pdf Instrucciones de instalación y configuración para Motor AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 páginas. Double swing gate motor kit

Imprimir página

Battery Connection for Bench Testing

ALWAYS TURN THE POWER OFF AND DISCONNECT THE BATTERY BEFORE MAKING

Slave Motor Power Wires and

Connection Terminal Block

Connect a 2 core wire (1.5mm Twin Active cable) from the slave motor connection terminal block

to the unused motor terminals on the circuit board.

Battery Connection

Double piggy back spade

connectors for solar power or

single spade connectors for

transformer power

Place the battery on the bench between the motors

Refer to the "DC 2 Circuit Board" data sheet included with this manual and locate the battery

wires on the circuit board. Ensure the battery wires are correctly connected to the correct

terminals on the circuit board. Connect the other end of the battery wires to the battery terminals

on the battery. Note the polarity (

battery terminal). The board should now be powered and great care should be taken to avoid

shorting out or otherwise damaging the circuit board.

WARNING: Care should be taken as there are moving components inside the

gate motor that may cause damage or personal injury.

Pre-Installation Set Up and

Testing

Double Swing Gate

ANY WIRING CONNECTIONS

2 Core 1.5mm

Twin Active

Cable

Red

wire to

Red

Motor M2

Terminals

battery terminal, Black / Blue wire to Black

Battery

Wires

Motor M1

Terminals