AUSTRALIAN MADE GREAT MATE Instrucciones de instalación y configuración - Página 8

Navegue en línea o descargue pdf Instrucciones de instalación y configuración para Motor AUSTRALIAN MADE GREAT MATE. AUSTRALIAN MADE GREAT MATE 20 páginas. Double swing gate motor kit

Imprimir página

Refer to the "DC2 Circuit Board" data sheet included with this manual and locate the direction LED's on

the circuit board. The GREEN LED indicates opening direction and the RED LED indicates closing

direction.

ALWAYS TURN THE POWER OFF AND DISCONNECT THE BATTERY BEFORE MAKING

Activate the gate motor using one of the handset remote. When the gate motors are first activated only

one motor may operate to synchronise both motors. If this happens, wait for the gate motor to complete

its rotation and stops.

Check the rotation of the motor shafts are turning in the correct directions for opening the gate and the

GREEN LED light is on OR the correct directions for closing the gate and the RED LED light is on. The

motors should rotate in opposite directions.

If one of the motors is going in the wrong direction, disconnect all power. Refer to the "DC2 Circuit Board"

data sheet included with this manual and locate the 'Motor M1' and Motor M2 terminals on the circuit

board. Identify which motor is going in the wrong direction and the motor terminals the motor is connected

to (Motor M1 Terminals OR motor M2 Terminals). Swap the red and black motor wires (or white wire as

per photo below) connected to Motor terminals on the circuit board. The red wire should be connected to

the terminal that had the black wire (or white wire as per photo below) connected to it and the black wire

(or white wire as per photo below) should be connected to the terminal that had the red wire connected to

it. This will reverse the direction of the motor.

Press the handset again to stop the motors and press the handset again to reverse the motor direction.

To stop the motor, press the remote handset or disconnect a battery lead.

Care should be taken as there are moving components inside the gate mo-

tor that may cause damage or personal injury.

Pre Installation Set Up

and Testing

Double Swing Gate

Setting Motor Direction

ANY WIRING CONNECTIONS

Motor

Wires

Motor M2

Terminals

Battery Wires

Motor M1

Terminals