BENDIX BDW 10 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Lavavajillas BENDIX BDW 10. BENDIX BDW 10 16 páginas. Tricity bendix instruction booklet dishwasher bdw 10

Imprimir página

Detergent dispenser (5)

Only use detergents specially designed for dishwashers.

Pour the detergent into the compartment, for a normal

load pour about 15g. Since not all detergents are the

same, you should also consult the instructions on the

packet. Remember that the instructions usually refer to

full-size dishwashers, for example when using detergent

tablets, it is sufﬁcient to use just half a tablet. Using the

correct amount of detergent also contributes to reducing

pollution.

Bendix recommends the use of Finish dish-

washer detergent and Rinse Aid.

Water softener (6)

This dishwasher is equipped with a water softener for hard

(chalky) water, therefore the rinse aid dispenser should

be set for a low dosage.

The lime (chalk) in hard water causes white deposits to

occur on dishes and the interior of the dishwasher.

To prevent this, the water has to pass through a special

container where its hardness is removed. Since the water

softener consumes coarse dishwasher salt, you will have

to replenish the salt container after a certain number of

dishwashing cycles. When the indicator lamp on the

control panel lights up, it is time to ﬁll up with salt.

Proceed as follows:

1. Unscrew the salt container ﬁller cap.

2. Fill up salt container with water (only the ﬁrst

time).

3. Fill the container with coarse salt. Use the funnel

supplied with the machine.

Ordinary domestic salt will affect the efﬁciency

of the water softener and damage it.

4. Remove the funnel and wipe off any spillage.

5. Screw the ﬁller cap back in place.

The salt container holds about 1 litre, which is enough for

about 20 - 30 dishwashing cycles. Always ensure that

there is water in the salt container before ﬁlling with salt.

Water softener plug (7)

As supplied from the factory, the water softener is set for

a water hardness of up to 20°dH. If your water is harder

than this, you can increase the capacity of the water

softener by pulling out the rubber plug at the rear of the

dishwasher on the left hand side viewed from the back.

See illustration.

Contact your local Water Authority to ﬁnd the exact water

hardness level for your area.

Never run the dishwasher without salt in the container as

this may damage the water softener. If the damage is slight,

the water softener function can be partially restored by

ﬁlling the container with salt and then running the Normal

cycle 4-5 times.

Cleaning the cabinet

Wipe the outside of the cabinet and control panel regularly

with a soft damp cloth. If necessary, use warm soapy water,

rinse with a damp cloth and rub dry with a soft duster.

Never use abrasive cleaners which could damage the

surface, ie: scouring pads or solvents (acetone, trichlori-

ethylene, etc).

If the machine is not going to be used for some time, take

the folllowing precautions:

1. Unplug the machine and turn off the water supply.

2. Fill up the rinse aid container.

3. Make sure the tub is clean by carrying out a wash

programme (without any crockery) using Finish

Dishwasher cleaner, then dry the inside thoroughly.

4. Leave the door ajar.

- 5 -