Gage Bilt GB708LGP Manual de instalación - Página 3

Navegue en línea o descargue pdf Manual de instalación para Herramientas Gage Bilt GB708LGP. Gage Bilt GB708LGP 8 páginas. Hydraulic tool

Imprimir página
MUST BE UNDERSTOOD TO AVOID
SEVERE PERSONAL INJURY
WARNING
Do not pull fastener unless it is placed in an
assembly, pin will eject forcibly when pintail breaks
off. Severe personal injury may result.
WARNING
When operating, repairing or overhauling tool, wear
approved eye protection. Do not look in front of tool
or rear of tool when installing fastener.
WARNING
Do not operate if deflector, bottle, catcher bag or
vacuum tube is removed or damaged, broken
pintails may eject forcibly from rear of tool. Severe
personal injury may result.
Keep tool clean and free of chips and debris.
Do not use beyond the design intent.
WARNING
Tool must be maintained in a safe working
condition at all times and examined on a regular
daily basis for damage or wear. Any repair should
be done by qualified personnel trained on Gage Bilt
procedures.
WARNING
Where prolonged use is foreseen, it is
recommended a tool balancer be used. Check
suspension device to ensure that it is secure.
Do no use tool in explosive atmosphere.
S/N: 1107 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.

SAFETY WARNINGS

PLEASE READ THIS MANUAL BEFORE
SERVICING OR USING THIS TOOL.
WARNINGS:
CAUTION
CAUTION
WARNING
CAUTIONS:
SHOW CONDITIONS THAT WILL
DAMAGE EQUIPMENT OR STRUCTURE
It is recommended operator wear a suitable glove
during operation where prolonged use is expected.
Always disconnect tool from power before
performing any maintenance to any tool. Ensure
that all connections are proper and there are no
visible leaks from tool or hoses before connecting
Risk of crushing exists. Be sure there is adequate
clearance for tool and operator's hands before
proceeding. Keep fingers clear of any moving
parts. Keep fingers clear from fasteners and
installed materials. Severe personal injury may
It is required to use hearing protection. A test was
carried out in a simulated work environment where
the background level was 73.2 dB (A). In this
condition the max level was 81.5 dB (A). Therefore,
it is required where prolonged use, hearing
protection be used.
It is recommended tool be operated 50 out of every
60 minutes, where prolonged use is expected.
Tool is not to be used as a hammer.
Hydraulic pressure not to exceed 5,600 PSI (386.1
bar) pull 2,400 (165.5 bar) reload
3
WARNING
Shock:
WARNING
to power.
WARNING
result.
WARNING
WARNING
CAUTION
CAUTION
REV. 7/14