GREAT PLANES J-3 ElectriCub Manual de instrucciones - Página 12
Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES J-3 ElectriCub. GREAT PLANES J-3 ElectriCub 20 páginas. Electric sport-scale arf
Imprimir página
2. Drill a 1/16" [1.6mm] hole on each mark and attach the
plywood guides using two 2 x 5mm washer head self-tapping
screws shown in the photo. Do this for both sides.
3. On each side of the battery compartment, center and
drill a 1/16" [1.6mm] hole and attach the remaining two
guides using the two remaining 2 x 6mm round-head
self-tapping screws.
4. Attach the wing to the fuse using rubber bands.
5. Use the included yellow thread to make the wing
struts. Take one length of thread and run it through both
guides on one side of the wing. Then tie the ends to the
guide installed on the fuse. Add a small drop of CA to the
knot to secure it. Do this for both sides. Removal of the wing
can be accomplished by unscrewing the two guides from
the bottom of the fuse.
GET THE MODEL READY TO FLY
Final Radio Hook Up
1. Complete the radio installation by connecting the ESC
and servos to the receiver. The receiver antenna should be
run out of and taped to the bottom of the fuselage. Do not
cut off the excess antenna; let it hang from the aft end of the
fuselage. Be sure to provide a strain relief for the receiver
antenna as shown.
12