GREAT PLANES Kunai Manual de instrucciones - Página 11
Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES Kunai. GREAT PLANES Kunai 17 páginas. Model aircraft great planes kunai
Imprimir página
Install the Motor and ESC
Do not mount the propeller until instructed to do so.
❏
1. Cut off the three motor wires 1/4" [6mm] from the end
of the ESC.
❏
2. Strip, twist, then tin the exposed wire as shown in the
image (for illustration purposes the middle wire has been
stripped and twisted and the top wire has been tinned in
preparation for re-soldering on the bullets).
❏
3. Unsolder the bullet connectors from the cut off wires
and solder them back onto the ESC. The best way is to heat
the bullet, then insert the wire into the molten solder in the
bullet and allow it to harden.
❏
4. Insulate the bullet connectors with 3/16" [5mm] shrink
tubing, then connect the ESC to the motor so the motor will
turn the correct direction (this will require temporary connection
of the receiver and a battery). Guide the lead wire from the
ESC down under the servo tray. Then, use thin, double-sided
foam tape to mount the ESC to the fuselage side. NOTE: Be
certain the motor wires do not rub against the motor.
❏
5. Attach an approximately 2-1/2" [60mm] strip of the
rougher, "hook" side of the included adhesive-back hook-
and-loop material to the bottom of the fuselage as shown.
For added security, apply a few drops of thin CA around the
edges of the strip to glue it down to the fuselage.
Install the Servos and Receiver
Refer to this photo while performing fi nal radio installation.
❏
1. Place the elevator and rudder servos in the servo tray,
but do not screw them down yet.
11