GREAT PLANES Micro Whizz Manual de instrucciones - Página 6

Navegue en línea o descargue pdf Manual de instrucciones para Juguete GREAT PLANES Micro Whizz. GREAT PLANES Micro Whizz 16 páginas.

ASSEMBLY OF THE MODEL

1. Locate the carbon fiber tail boom and note the pre-cut

slot for the pushrods to exit. Cut a piece of 1/16" [1.6mm]

balsa 3/4" [19mm] x 4" [102mm]. Also cut 2 squares of 3/32"

[2.4mm] balsa 1" [25mm] x 1" [25mm]. Note: Wood not

supplied with kit.

2. Slide the 1/16" balsa strip into the pre-cut slot. Place

this onto a flat surface and slide the 3/32" balsa squares

under the strip as shown in the above photograph. Locate

the tail bracket and test fit it into place on the end of the tail

boom making sure that both sides of the bracket touch the

flat surface. Make sure that the bracket is flush with the rear

of the tail boom and the pre-cut slot in the bracket is facing

toward the rear. When satisfied with the fit, glue the bracket

into place using medium CA.

3. With a 3/64" [1mm] bit, drill a hole in the tail boom at

the forward end of the pre-cut slot in the bracket.

4. Use a sharp hobby knife to cut the covering away from the

slot in the center of the leading edge of the horizontal stabilizer.

5. Measure the width of the horizontal stabilizer and

mark a centerline on the bottom of the stabilizer with a felt-

tipped pen as shown above.

6. Measure 3/16" [5mm] forward from the trailing edge of the

horizontal stabilizer at the centerline and mark this location.