ADEMCO Honeywell 5806 W3 Manual de solución de problemas - Página 3
Navegue en línea o descargue pdf Manual de solución de problemas para Sensores de seguridad ADEMCO Honeywell 5806 W3. ADEMCO Honeywell 5806 W3 9 páginas. Smoke & heat detector
Imprimir página
Smoke & Heat Detector Troubleshooting
Out of
Off
Sensitivity
DSC WS4916
These trouble conditions apply to the
detector has one LED light and a sounder to indicate the detector's status.
State
LED
Normal
Blinks every 50
(Standby)
seconds
Blinks every 1
Smoke Alarm
second
Thermal
Blinks every 1
https://alpha.adt.com/help/89[11/12/2018 9:58:31 PM]
Blinks every 5
Off
seconds
DSC WS4916
wireless smoke detector. This smoke
Sounder
Alarm Mode
Off
None
Pattern or
In Alarm
steady
Pattern or
A problem has been detected with
the smoke detector. The smoke
detector compensates for long term
changes in the environment
resulting from dust and other
factors. This automatic
compensation sensitivity needs to
be reset by a technician. Please
refer to the
Contact Us
Action
The device is operating normally. No
action needed.
Smoke has been detected. ADT has
been contacted. Press the test
switch to silence the smoke detector
sounder for 5 minutes. If necessary,
silence the alarm keypad.
Remove the source of the smoke, if
it can be done safely. If necessary,
fan the smoke detector for a few
minutes to further dissipate any
smoke or particles. If the device still
indicates a problem, it may be
necessary to clean it. Please refer to
Caring for Your Smoke Detector
below.
The unit has detected that the
temperature is above 135 F. ADT
has been contacted. Press the
recessed test switch to silence the
smoke detector sounder for 5
page
o