Dynaphos Starter SK-200 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Linterna Dynaphos Starter SK-200. Dynaphos Starter SK-200 8 páginas. Studio flash

Flash control

Starter SK studio flash has power range from 1/1 to 1/8 (4 EV), which can be adjusted through the flash

output controller

(see pic. 2)

3.0. Up arrow button serves to increase the power output, respectively, the one with arrow down serves to

decrease the power output. Please notice, that after decreasing the power output you need to fire the flash

ones to discharge the capacitors to the set lower power. If you reduce the power output with one more

increment under 1.0, the digial display will show "OF" symbol and the flash will stay turn on, but it won't

be able to fire a flash.

Starter DE studio flash has fully manual control of the modeling light. To turn on or off the modeling lamp,

press the button 3. You can steplessly control the modeling lamp in 9 steps, which will be shown on the back

panel with the symbols L1 tо L9. For this purpose hold the button 3, until the modeling lamp power output

indication shows on the back panel and start blinking (L1 до L9). Through the buttons

output and when it's done , press once the button 3. When the flash is on and idle for more than two hours

, the modeling lamp will automatically turn off. Restart the flash to turn it back on.

Overload and overheat protection

During continious work with the flash (large number of flashes for a short term), an overheating may occur.

To protect the flash, don't make more than 20 flashes in a row with higher power output (2.0 - 3.0). After

every 20 contiguous flashes leave the flash to cool down for at least 3 min.

When working with light control accessories such as spots, which are preventing the cooling, you have to

limit the modeling light use and the flash shouldn't be used too intense.

If the flash is used carelessly about its temperature this may cause failure, in which case Dynaphos Ltd.

reserves the right to refuse warranty repair.

in 20 steps and it's shown on the digital display

Guide

with numbers from 1.0 to

adjust the power