Dynaphos Starter SK-200 Manual de instrucciones - Página 7

Navegue en línea o descargue pdf Manual de instrucciones para Linterna Dynaphos Starter SK-200. Dynaphos Starter SK-200 8 páginas. Studio flash

- choose a working channel via the selector

from the power switch

- place the receiver in the USB sync port

set on the same channel as the sender (check the further picture).

From the selector

choose a working group. For work with more than

one flash, you'll have to place a corresponding number of additional

receivers FTR-16

(product № 010289)

the same channel as the sender. Preferably, the receiver of each flash

has to be set on a different group in order each flash to be control

separately.

- choose a working group (a flash) from the selector of the sender; to

change the power output of the flash use the "-/+" button 5; through

the "Lamp" button

through the "Buzz" button

through the "Test" button

- the transmitter is designed for different models lightning. To work

with Starter SK-200, hold down the button "Set" 4 until the screen

display number 1.0

- when pressing a button the indicator

pen place a new batteries and try again.

- after finnishing work turn off the sender from the power switch

- keep the antenna

save from mechanical damage

of the flash

for each flash and set them on

you can turn on or off the modeling light;

you can turn on or off the sound signal;

you trigger the flash or make a test flash.

must flash, if this don't hap-

and turn on the sender

(see p. 2)

and

Guide