AFL MFP Manual de consulta rápida - Página 11

Navegue en línea o descargue pdf Manual de consulta rápida para Equipos de prueba AFL MFP. AFL MFP 17 páginas. Multi-fiber identification system

Measuring Optical Power with MFP

It is important to keep all optical connections and surfaces clean to ensure accurate

measurements and operation. Always clean all test jumpers before conducting tests.

1. Turn On the MFP and verify that it is in regular test mode. If MFP is in the Fiber

ID mode, press the Fiber ID button to switch to the regular power meter mode.

2. Select the appropriate fiber optic test jumper. The fiber type of this jumper must

be the same as the fiber type normally connected to the output being measured.

3. Mount the appropriate adapter cap on the MFP port. This adapter cap must

match the connector on the end of the test jumper you will connect to the MFP.

4. Connect one end of the test jumper to the MFP adapter cap and the other end to

the optical output to be measured.

5. Press [ ] to select wavelength that matches the nominal wavelength of the

source being measured.

6. Press [dB/dBm/µW] to display power in [dBm] or press and hold to display power

in [µW].

Test jumper

Adapter cap

-20 dBm

MFP

Output

Input

Fiber optic equipment