Gama Sonic 94B003 Manual de instrucciones - Página 3
Navegue en línea o descargue pdf Manual de instrucciones para Linterna Gama Sonic 94B003. Gama Sonic 94B003 4 páginas. Victorian bulb solar lamp post
Assembly Instructions
94B001
1. Using the provided template, mark and drill three holes into concrete
no larger than the provided anchors (G).
NOTE: For installation in the ground where pouring concrete is not preferred or
possible, use our EZ Lamp Post Anchor, model 30001 (sold separately) to quickly and
easily secure the lamp anywhere in your yard. This is only to be used with model
94B001.
2. Place the anchors (G) into the holes with
the threaded ends facing up.
3. Place the Base Pole (F) over the
anchors and secure using a wrench.
Cover the nuts with the provided
plastic covers.
4. Place the middle pole (E) on top of
the base pole (F) and secure with the
provided screws.
5. Attach the top pole (D) to the middle
pole (E), and the spacer pole (C) to the
top pole (D) by screwing the poles
clockwise.
6. Attach the fixture (B) to the spacer
pole (C) by twisting clockwise.
94B002/94B003
1. Using the provided template, mark and drill three holes into concrete
no larger than the provided anchors (G).
above for steps 1-5)
2. Place the anchors (G) into the holes with the threaded ends facing
up.
3. Place the Base Pole (F) over the anchors and secure using a wrench.
Cover the nuts with the provided plastic covers.
4. Place the middle pole (E) on top of the base pole (F) and
secure with the provided screws.
5. Attach the top pole (D) to the middle pole (E),
and the spacer pole (C) to the top pole (D) by
screwing the poles clockwise.
6. Remove the finial cap (K) from the centerpiece
(H/I) by removing the screws.
7. Insert one of the fixtures with arms (J) into the
centerpiece (H/I).
8. Screw in two bolts through the holes in the arm (J)
into the centerpiece (H/I) using the supplied hex
wrench.
9. Secure the two bolts using a nut inside the
centerpiece (H/I)
10. Repeat the installation for the second and third
lamp head (only second if installing double head
lamp).
11. Replace the finial cap (K) on the centerpiece (H/I) and
secure using the screws removed earlier.
12. With the help of another person, place the
assembly of lamp heads and centerpiece
(H/I) on top of the spacer pole (C) and twist
clockwise until fully attached to the pole.
page 3
(follow along with illustration
Operation Instructions
1.
Remove the top (A) from the Fixture by removing the two screw
caps.
2.
Install the GS Solar LED Bulb by holding it by the base and twisting
it clockwise into the socket.
3.
Replace the top (A) back on the fixture and secure with the two
screw caps.
4.
Using the external switch, select your desired setting.
Low = Softer light output and longer duration
High = Brighter light output
5.
The lamp will operate automatically at dusk.
Replacement Parts
Replacement Batteries and Bulbs are available at
www.gamasonic.com or via our Toll Free number: +1-800-835-4113
Your Lamp can use the following bulbs:
C37WW10W – included bulb with Warm White LEDs (2700K)
C37BW10W – bulb with Bright White LEDs (6000K)
F30WW05W – Flame bulb with simulated flame LEDs
T45WW10W – Edison LED Bulb with Warm White LEDs (2700k)
Your Lamp uses the following batteries:
GS32V30