MAINLINE ML135W Instrucciones de instalación Cuidado y mantenimiento - Página 4

Navegue en línea o descargue pdf Instrucciones de instalación Cuidado y mantenimiento para Aseos MAINLINE ML135W. MAINLINE ML135W 11 páginas. Round front toilet

Imprimir página
Round Front Toilet
Devant de cuvette rond
Installation Instructions, Care and Maintenance

Troubleshooting Guide

Problem
Does not flush
Poor or sluggish flush
Toilet leaks
Toilet does not shut off
Repair Parts List
Part #
Description
400A
Fill Valve
510A
Flush Valve
Possible Cause
a. Water supply valve closed
b. Supply line blocked
c. Flush valve chain is too loose or
disconnected
d. Sand or debris lodged in water control
a. Bowl water level too low
b. Supply valve partly closed
c. Partially clogged trapway and/or drain
pipe and/or vent
d. Supply pressure too low
a. Poor supply line connection
b. Poor bowl to tank/floor connection
a. Flush valve chain too tight, holding
flapper open
b. Flush valve seat and/or flapper worn or
deformed
c. Sand or debris lodged in water control
VITREOUS CHINA
Corrective Action
a. Open valve and allow water to fill tank
b. Shut off water supply, disconnect supply line, and
inspect all gaskets and washers. Reassemble
c. Readjust chain length as required
d. Shut off water supply. Remove cap and clean per
Step 12
a. Check that refill tube is connected to water control
and inserted into tank overflow without being
kinked or damaged
b. Open supply valve fully. Be sure that proper supply
tube size is used
c. Remove obstruction.
Consult a plumber if neccessary
d. Normal supply pressure must be at least 20 psi
a. Review Step 8 of installation procedure
b. Review Step 4 through 6 installation procedure
a. Readjust chain length as needed. Review Step 9
b. Replace flapper/flush valve assembly, as needed
c. Shut off water supply. Remove cap and clean per
Step 12