AGT INDUSTRIAL AGT-SSRPB80 Manual del producto - Página 9
Navegue en línea o descargue pdf Manual del producto para Maquinaria agrícola AGT INDUSTRIAL AGT-SSRPB80. AGT INDUSTRIAL AGT-SSRPB80 18 páginas. Skid steer rock picker bucket
Imprimir páginahttps://www.agrotkindustrial.com/
Installation
Unpack and check
Check for missing or damaged components according to the packing list.
If you have any questions, please contact the supplier. List of details
As the table above:
Machine installation
Equipment must be installed on a solid concrete floor or similar. If the ground is not firm, it will
not be able to connect to the loader. There should be a space around the device for easy
operation.
Connecting Brush Cutter
Connecting Rock Bucket Consult your skid steer operator's manual for specific instructions on
how to connect to your rock bucket loader.
General Attachment Method
1. Make sure the hydraulic lines are clear from the front side of the rock bucket attachment
plate and that the locking pins on the skid steer mounting plate are retracted.
2. Drive forward and place top of skid steer mounting plate under the attachment mounting
flange. See Figure below.
3. 3. Slowly raise and tilt back the skid steer mounting plate untilthe brush cutter attachment
plate rests flat against the skid steer mounting plate.
4. Activate your skid steer's lever lock switch to engage and lock the pins into the flange slots
of the brush cutter's attachment plate. If your skid steer does not have this switch, push the
latch handles down until you can see the lock pins extend into the attachment flange.
5. Connect the attachment hydraulic hoses and the case drain hose (SBCNS model only) to
the auxiliary supply couplers located on your skid steer loader lift arm.
Skid Steer Mounting Plate to Attachment Mounting Flange
7