GameChanger Audio BIGSBY Manual de inicio rápido - Página 5

Navegue en línea o descargue pdf Manual de inicio rápido para Pedal de música GameChanger Audio BIGSBY. GameChanger Audio BIGSBY 8 páginas.

ADDITIONAL FUNCTIONALITY

MIDI In Connector

The BIGSBY Pedal can be fully controlled via MIDI CC and PC messages

(see MIDI CC and PC map sheet included).

Connect the BIGSBY Pedal to the MIDI OUT of your interface or

controller using a standard MIDI cable and the 3.5 mm TRS to 5 pin DIN

MIDI adapter (Type B) included with the BIGSBY Pedal.

EXP Out / FSW In Connector

The EXP Out / FSW In connector on the BIGSBY's back panel is designed for dual purpose

functionality:

The BIGSBY can be used as an Expression pedal to control external gear with an EXP input.

In this setup the BIGSBY Pedal is in front of the signal chain and is also

Pedal´s EXP input

- functioning as a pitch shifter and an expression controller simultaneously.

The BIGSBY Pedal's EXP Out settings - RANGE, DIRECTION and OFFSET - are adjusted

separately in the SETTINGS MENU (see page 6).

The BIGSBY can also be used outside of the signal chain, as an Expression pedal only,

but it still needs to be connected to a power source.

The BIGSBY Pedal can be put into LATCH mode with a standard external footswitch.

Pressing the footswitch will activate LATCH mode (indicated by the SELECT button).

When latched - the BIGSBY will produce a constant pitch-shift determined by the current

position of the DEPTH knob.

This way you don't have to hold down the BIGSBY Pedal for long phrases.

In LATCH mode you can still use the BIGSBY's foot-pedal to make momentary dives and detune

eﬀects up to two semitones.

By pressing the opposite side of the foot-pedal the pitch shift's direction will be ﬂipped.

¼" jack cable

TRS

The BIGSBY Pedal´s FSW In connector is compatible with all

standard momentary or toggle type footswitches with a TS

(Tip/Sleeve) ¼" jack (normally closed or normally open).

You can also use a dual latching footswitch with a TRS jack - in

this case only one side of the footswitch will work.

connected to the LIGHT