Adexa CP-105IR Manual del usuario - Página 3

Navegue en línea o descargue pdf Manual del usuario para Horno Adexa CP-105IR. Adexa CP-105IR 6 páginas. Electric adjustable conveyor oven

ii. The top and bottom heater elements have individual heat control switches which have 7

settings :

a. "1" – Position is the lowest temperature setting

b. "1 - 7" – the heat will vary from low to high where "1" is the lowest setting and 7 is the

highest setting.

3.5. When using the machine select switch positions according to requirements and allow

approximately 5 minutes for operating temperature to be attained. As described above

product appearance or colour is dependent on conveyor speed, heat settings and product.

Please note that a number of factors can affect the toasting colour.

i. Moisture content of the product

ii. Sugar content of the product

iii. Initial product temperature

Generally for best results use day old bread stored at room temperature.

3.6. Turn on the main switch the conveyor will now run. Set the temperature to approx.

400F which equates to 5.7 on the scale. Any high-quality edible oil can be used with

this conveyor oven. It is preferable to use oil specifically suited for use in

toasters/ovens. The pilot cycle cycles with the heating element and indicates when

the heater is on. It is preferable to wait until the unit has reached operating

temperature and the light has cycled on and off twice. Try to toast two pieces of bread

to see whether the color is good or not, and adjust the speed of the chain net. If want

the color deepen, turn the color controller to right to go over "3" position. (Notice:

the more graduation and lower chain net speed, the color of the bread will deepen. As

the visa.) After adjusting the speed of the chain net, put the bread into the chain net

follow the tray. The bread will go with the chain net into the inside of the unit and

toasting in the inside of the unit.

3.7. After finished working, turn the main switch to "OFF" position and pull the plug out.

3.8 If the wire was damaged, replace it by the manufacturer or service agent and the

qualified person only, in order to avoid dangerous

4. Clean and maintenance

Note: THE UNIT MUST BE DISCONNECTED FROM THE POWER SOURCE

AND ALLOWED TO COOL DOWN BEFORE CLEANING TAKES PLACE

4.1.After finished a day's work, pull out the tray and clean it. Use the soft wet towel that

has not corrosive clean preparation to cleaning the unit. Do not wash the unit with water

jets.

4.2.To prevent the unit to be polluted and effect the unit's function, do not use the unit to

toast the food that content too much sugar in the surface or the food will flow and

stick after heating.