IKEA 302-371-38 Manual - Página 16

Navegue en línea o descargue pdf Manual para Placa IKEA 302-371-38. IKEA 302-371-38 44 páginas.
También para IKEA 302-371-38: Manual (44 páginas)

Imprimir página

ENGLISH

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Loose and inappropriate plug and

socket connections can make the

terminal overheat.

• Have the clamping connections correctly

installed.

• Use strain relief clamp on cable.

• Follow the connection diagram (it is

located on the underneath surface of the

casting of the hob).

Important!

• You must observe the minimum distances

to other appliances and furniture

cabinets or other units according to

Assembly Instruction.

• If there is no oven beneath the hob insert

a dividing panel at a minimum distance

of 20 mm from the bottom of the hob.

• Protect the cut surfaces of the worktop

against moisture using a suitable sealant

included in the product in fitting bag. The

sealant seals the appliance to the work

top with no gap.

• Do not use silicon sealant between the

appliance and the worktop. Avoid

installing the appliance next to doors

and under windows as hot cookware

may be knocked off the rings when doors

and windows are opened.

• Only an authorized service engineer can

install, connect or repair this appliance.

Use only original spare parts.

Electrical connection

• Before connecting, check that the

nominal voltage of the appliance stated

on the rating plate, corresponds to the

available supply voltage. Also, check the

power rating of the appliance and

ensure that the wire is suitably sized to

suit the appliance power rating (refer to

the "Technical information" chapter). The

rating plate is located on the lower

casing of the hob.

• The appliance is supplied with a

connection cable. This has to be

provided with a proper plug, able to

support the load marked on the

identification plate. To connect the plug

to the cable, follow the recommendation

given in following figure.

Replacement of the connection cable

• The replacement of the connection cable

requires the specific equipment of a

technician. Only an original spare part

able must be used, provided by spare

parts service. The plug has to be fitted in

a proper socket. If connecting the

appliance directly to the electric system,

it is necessary that you install a double

pole switch between the appliance and

the electricity supply, with a minimum

gap of 3 mm. between the switch

contacts and of a type suitable for the

required load in compliance with the

current rules.

• The connection cable has to be placed in

order that, in each part, it cannot reach a

temperature 70 °C higher than the room

temperature. The brown (or black) phase

cable (fitted in the terminal block contact

marked with "L") must always be

connected to the network phase.