®
PARTNER
Advanced Communications System Installation, Programming, and Use
Canadian Department of Communications (DOC)
Interference Information
The Industry Canada (IC) label identifies certified equipment. This certification means that the
equipment meets certain telecommunications network protective, operational, and safety
requirements. The IC does not guarantee the equipment will operate to the user's satisfaction.
Before installing this equipment, users should ensure that is permissible to connect it to the
facilities of the local telecommunications company. The equipment must also be installed using an
acceptable method of connection. In some cases, the company's inside wiring for single-line
individual service may be extended by means of a certified connector assembly (telephone
extension cord). The customer should be aware that compliance with the above conditions may not
prevent degradation of service in some situations.
Repairs to certified equipment should be made by an authorized Canadian maintenance facility
designated by the supplier. Any repairs or alterations made by the user to this equipment, or any
equipment malfunctions, may give the telecommunications company cause to request the user to
disconnect the equipment.
Users, for their own protection, should ensure that the electrical ground connections of the power
utility, telephone lines, and internal metallic water pipe system, if present, are connected. This
precaution may be particularly important in rural areas.
CAUTION:
Users should not attempt to make such connections themselves, but should contact the
appropriate electrical inspection authority or electrician, as appropriate.
To prevent overloading, the Load Number (LN) assigned to each terminal device denotes the
percentage of the total load to be connected to a telephone loop used by the device. The
termination on a loop may consist of any combination of devices subject only to the requirement
that the total of the Load Numbers of all the devices does not exceed 100.
IC Certification No: See the label on the side of the control unit.
A. Customer Support
10
Imprimir página