Alivida Steam 9 Manual de instalación y uso - Página 7
Navegue en línea o descargue pdf Manual de instalación y uso para Generador portátil Alivida Steam 9. Alivida Steam 9 18 páginas. Generator for steam bath/hammam
Imprimir página
Installation piping:
The generator must be connected to a drinking water supply. The connections to the
water mains must be made in accordance with local laws and regulations.
Use pipes with a suitable diameter:
Model
Alivida Steam 3
Alivida steam 6
Alivida steam 9
Alivida steam 12
The water supply pressure must always be between 1 and 6 bar (100-600 kPa). Install
a pressure regulator if necessary. Always use cold water, maximum 25 °C, to fill the
boiler; this is important for rinsing and cleaning the boiler. Do not perform welding work
on pipelines close to the steam generator. The heat and smoke this creates can
damage the generator.
Flush the pipework thoroughly to remove residues and impurities before connecting it
to the generator. When there is a risk of particles entering the water, even during
normal use, it is recommended to install a filter. Install a shut-off valve on the steam
generator's water supply. Always check that this valve is fully open when the generator
is on. Only close the valve if the generator will not be active for a long period of time.
The piping used for the discharge of the steam generator must be able to withstand
the flow of liquids warmer than 100 degrees Celsius. To ensure correct operation, this
pipe must be installed in a stable manner, with at least a 4º slope towards the drain.
There should be no obstacles that could hinder the management. It is recommended
to connect a siphon to the drain.
UNDER NO CONDITIONS may the steam pipe be fitted with shut-off valves, such as
valves or the like. The steam pipe must be made of a material that must permanently
withstand temperatures of at least 100 °C and must be insulated in such a way that
condensation is minimized. The steam line should slope gradually (at an angle of at
least 4º) from the generator to the steam outlet, so that the condensate that forms
when the system starts up can be properly drained. The steam outlet must be installed
on the inside of the steam bath at a height between 200 and 350 mm from the floor.
When installing and using the steam outlet, follow the instructions. The steam pipe
should never be longer than 6 metres.
Water inlet
½"
½"
½"
½"
7
Water outlet
½"
½"
½"
½"
Steamoutlet
½"
½"
2 x ½"
2 x ½"