Brother TD-4420TN Manual de instalación

Navegue en línea o descargue pdf Manual de instalación para Impresora Brother TD-4420TN. Brother TD-4420TN 2 páginas. Cutter module
También para Brother TD-4420TN: Manual del usuario (44 páginas)

Imprimir página

Installation Guide

Cutter Module (PA-CU-002, PA-CU-003)

TD-4420TN/TD-4520TN

NOTE

Only Authorized Brother Dealers should perform accessory replacements.

1. Open the printer's Top Cover and push the print head release button to open the

print head.

2. Remove the lower front panel.

3. Close the print head.

4. Remove the four screws on the media holder and then remove it, as illustrated

below.

5. Push the Cutter Module's cable and ground line through the slot into the main board

compartment.

Installation Guide

Cutter Module (PA-CU-003)

TD-4650TNWB/TD-4750TNWB

NOTE

Only Authorized Brother Dealers should perform accessory replacements.

1. Open the printer's Top Cover and push the print head release button to open the

print head.

2. Remove the lower front panel.

3. Push the Cutter Module's cable and ground line through the slot into the main board

compartment.

D01CNK001

Screws

(5 - continued)

6. Slide the Cutter Module into the lower front panel slot until it locks into place.

7. Connect the cable and ground line to the CON6 and JP2 sockets on the main board.

(The ground line can be connected to any available JP2 socket.)

8. Reattach the media holder using the four screws.

9. To complete the installation, load the media before you turn on the printer.

For more information about loading the media with the Cutter Module installed, see

the User's Guide.

4. Slide the Cutter Module into the lower front panel slot until it locks into place, and

then close the Top Cover.

5. Turn over the printer. Remove the six screws on the bottom cover and then remove

it, as illustrated below.

(To avoid scratching the LCD screen, place the printer on a soft cloth.)

Screws

6. Connect the cable and ground line to the CON6 and JP2 sockets on the main board.

(The ground line can be connected to any available JP2 socket.)

CON6 JP2

7. Reattach the Bottom Cover using the six screws.

8. To complete the installation, load the media before you turn on the printer.

For more information about loading the media with the Cutter Module

installed, see the User's Guide.

JP2

CON6