Indesit IT50D1 Manual de instrucciones - Página 5

Navegue en línea o descargue pdf Manual de instrucciones para Cocinas Indesit IT50D1. Indesit IT50D1 24 páginas. 50cm free standing electric cooker

Imprimir página

Disposing of the appliance

When disposing of the appliance please remove the

plug by cutting the mains cable as close as

possible to the plug body and dispose of it as

described above.

Adapting the cooker to different types of

gas

In order to adapt the cooker to a different type of

gas with respect to the gas for which it was

produced (indicated on the label attached to the lid),

follow these steps:

a ) a ) replace the hose holder mounted on the appliance

a ) a )

a )

with that supplied in the bag of "cooker

accessories".

b )

b )Replacing the burner nozzles on the hob:

b )

• remove the grids and slide the burners from their

housings;

• unscrew the nozzles using

a 7 mm socket spanner, and

replace them with nozzles for

the new type of gas (see table

1 "Burner and nozzle

characteristics").

• replace all the components

by repeating the steps in

reverse order.

c ) c )

c ) c ) Minimum regulation of the hob burners:

c )

• turn the tap to minimum;

• remove the knob and

adjust the regulation screw,

which is positioned in or next

to the tap pin, until the flame

is small but steady.

! in the case of liquid gas, the

regulation screw must be

screwed in to the bottom.

• check that the flame does not turn off when you

turn the tap quickly from high to low.

d )

d )Regulating the primary air of the burners:

The primary air of the burners requires no regulation.

Important

On completion of the operation, replace the old

rating sticker with one indicating the new type of gas

used. This sticker is available from our Service

Centres.

Note

Should the pressure of the gas used be different (or

vary) from the recommended pressure, it is

necessary to fit a suitable pressure regulator onto

the inlet pipe in compliance with current National

Regulations relative to "regulators for channelled

gas".