AEG SANTO C 7 14 40 i Instrucciones de uso e instalación - Página 6

Navegue en línea o descargue pdf Instrucciones de uso e instalación para Congelador AEG SANTO C 7 14 40 i. AEG SANTO C 7 14 40 i 14 páginas. Integrating fridge freezer
También para AEG SANTO C 7 14 40 i: Instrucciones de uso e instalación (29 páginas)

AEG SANTO C 7 14 40 i Instrucciones de uso e instalación

Disposal of old Appliances

For environmental reasons, refrigeration appliances must be disposed of
properly. This applies to your old appliance, and - at the end of its service
life - to your new appliance as well.
Warning! Before disposing of old appliances make them inoperable.
Remove plug from mains, sever the power cable, remove or destroy any
snap or latch closures, to prevent small children being trapped inside.
• Use an authorised disposal site.
Contact your Local Council or Environmental Health Office to see if there
are facilities in your area to recycle the appliance.

Remove transport packaging

The appliance and the interior fittings are protected for transport.
• Remove all adhesive tape and packing pieces from the interior of the
appliance.

Description of the appliance

D
E
F
G
H
I
6
A - Dairy compartment
B - Can storage shelves
A
C - Bottle storage shelf
D - Thermostat control
E - Glass shelves
B
F - Glass shelf
G - Salad drawers
H - Compartment for
storing frozen food
C
I - Compartment for
freezing fresh food
Fix cover (C) on guide (A) until it clips
into place.
Open the appliance door and the fur-
niture door at 90°. Insert the small
square (B) into guide (A). Put togeth-
er the appliance door and the furni-
ture door and mark the holes as indi-
cated in the figure. Remove the
squares and drill holes with ø 2 mm
at 8 mm from the outer edge of the
door. Place the small square on the
guide again and fix it with the screws
supplied.
At the end of installation/adjusting, it
is necessary to check if the door of
the furniture closes properly.
Should adjustment of the furniture
door be necessary, use the clearance
of slots.
A
C
PR33
8mm
A
B
PR167
PR168
23