AEG protect d. 2000 Manual de instrucciones de instalación y funcionamiento - Página 20

Navegue en línea o descargue pdf Manual de instrucciones de instalación y funcionamiento para Campana de ventilación AEG protect d. 2000. AEG protect d. 2000 25 páginas. Fume extractor hood

Imprimir página
Proceed as follows to remove and change my activated
carbon filter:
Switch of the fan motor by pressing the
Take the precaution of removing my cartridge fuses from
their fuse holders or tripping my automatic circuit
breaker to ensure the fan motor cannot be switched on
accidentally.
The activated carbon filter cannot be cleaned or reused.
Remove the metal filters.
Unscrew the two screws on the activated carbon filter
frame and remove the old filter. Fig. 2
Clean the inner housing using a hot detergent solution
only (never use caustic detergents, abrasive powders or
brushes).
Mounting the carbon filter:
Mounting the carbon filter:
Mounting the carbon filter:
Mounting the carbon filter:
Mounting the carbon filter:
Insert a new activated carbon filter into the carbon filter
Fig. 2
Fig. 2
frame. Fig. 2
Fig. 2
Fig. 2.
Close the activated carbon filter frame again using the
two screws provided.
Refit the metal filters.
Screw the fuses back in or reset the automatic circuit
breaker.
Proceed as follows to reset the filter saturation display
(counter): Select any fan speed using
and then press the
time, continuing to hold them down for at least 3 seconds
until the flashing letter C stops being shown on the
display (D) and then press the
The activated carbon filter display is now ready for use
again.
Fig. 2.
Fig. 2
Fig. 2
Fig. 2
B and
F buttons at the same
button B.
button.
E or
F buttons
45