Kohler Elevation 76665T-E Manual - Página 2

Navegue en línea o descargue pdf Manual para Sanitarios Kohler Elevation 76665T-E. Kohler Elevation 76665T-E 2 páginas. Plus slide shower

Imprimir página

INSTALLATION

1269145-AN2-A

How to Install the Slide Bar

Decide on a suitable position for the slide bar

avoiding buried cables and pipes in the wall.

Mark the wall fixing hole positions for the top

of the slide bar and drill two holes to suit the

bracket(1). Insert anchors(2) into the holes.

Fix bracket(1) to wall using screws(3).

Rehearse installation of the slide bar using

screws(5), slide bar(4) and lower bracket(8).

Mark the outline of the lower bracket on the

wall and find the position of the holes. Drill

two holes to suit the lower bracket. Insert

anchors(2) into the holes.

Fix lower bracket(8) to the wall using

screws(3).

Slide the handspray holder(9) onto the bar(4).

Adjust the holder to the proper position.

Tighten the slide bar kit with screws(5).

Slide the bracket covers(6) onto the bracket,

①

and install the slide bar end covers(7).

How to Install the Elbow and Handspray

NOTE: To perform installation the installer

must provide a G1/2" water supply nipple(10).

Distance from the end of the nipple to the

finished wall surface should be between 10

and 13mm and perpendicular to the wall.

Apply tape or thread sealant to the threads of

the water supply nipple.

Apply a ring of plumber's putty or sealant

around the back surface of the elbow(11).

Thread the elbow onto water supply nipple.

Adjust and make sure the outlet(12) faces

down.

Tighten hose(13) with seals(14) to elbow

outlet and to handspray(15).

Hang handspray on handspray holder(9).

②

INSTALLATION CHECKOUT

CLEANING INSTRUCTIONS

All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with clean soft

cloth. Many cleaners may contain chemicals, such as ammonia, chlorine, toilet cleaner etc, which could

adversely affect the finish and are not recommended for cleaning.

Do not use abrasive cleaners or solvents on Kohler faucets and fittings.

1269145-AN2-A

Ensure that all connections are tight.

Turn on the drain and main water supply and check

for leaks. Repair as needed.

Remove the handspray(15). Run hot and cold water

through hose(13) for about one minute to remove any

debris. Remove any debris from the handspray. Shut

off the main water supply. Reinstall the handspray.