Kohler Command Pro CH1000 Manual del usuario - Página 14
Navegue en línea o descargue pdf Manual del usuario para Motor Kohler Command Pro CH1000. Kohler Command Pro CH1000 21 páginas. Horizontal/vertical shaft
También para Kohler Command Pro CH1000: Manual del usuario (8 páginas)
Imprimir página
Battery Charging
WARNING: Explosive Gas!
Batteries produce explosive hydrogen gas while being charged.
To prevent a fire or explosion, charge batteries only in well
ventilated areas. Keep sparks, open flames, and other sources of
ignition away from the battery at all times. Keep batteries out of
the reach of children. Remove all jewelry when servicing
batteries.
Before disconnecting the negative (-) ground cable, make sure
all switches are OFF. If ON, a spark will occur at the ground
cable terminal which could cause an explosion if hydrogen gas
or gasoline vapors are present.
NOTE: Do not apply 12 volt DC to kill terminal of
ignition module.
Fuel System
Fuel Filter
Most engines are equipped with an in-line fuel filter.
Periodically inspect the filter and replace with a
genuine Kohler filter seasonally or every 150
operating hours.
Fuel Line
These engines use Low Permeation SAE 30 R7 rated
fuel line; certified to meet emission requirements.
Standard fuel line may not be used. Order
replacement hose by part number through a Kohler
Engine Service Dealer.
Figure 25. Low Permeation Fuel Line.
Carburetor Troubleshooting and
Adjustments
These engines use a Keihin BK two-barrel carburetor
with fixed main jets, and fixed or limiter-equipped
low idle fuel adjusting needles. See Figure 26. In
compliance with government emission standards, the
carburetor is calibrated to deliver the correct fuel-to-
air mixture to the engine under all operating
conditions. Adjustments are made as follows.
14
Idle Fuel
Adjustments
Drain Screw
Figure 26. Keihin Two-Barrel Carburetor.
NOTE: Carburetor adjustments should be made only
after the engine has warmed up.
NOTE: To ensure correct engine operation at altitudes
above 1525 meters (5000 ft.), it may be
necessary to have an authorized Kohler dealer
install a special high-altitude jet kit in the
carburetor. If a high-altitude kit has been
installed, the engine must be reconverted to
the original jet size, before it is operated at
lower altitudes, or overheating and engine
damage can result.
Troubleshooting
If engine troubles are experienced that appear to be fuel
system related, check the following areas before
adjusting the carburetor.
• Make sure the fuel tank is filled with clean, fresh
gasoline.
• Make sure the fuel tank cap vent is not blocked and
that it is operating properly.
• If the fuel tank is equipped with a shut-off valve,
make sure it is open.
• If the engine is equipped with an in-line fuel filter,
make sure it is clean and unobstructed. Replace the
filter if necessary.
• Make sure fuel is reaching the carburetor. This
includes checking the fuel lines and fuel pump for
restrictions or faulty components, replace as
necessary.
• Make sure the air cleaner element is clean and all
air cleaner element components are fastened
securely.
If, after checking the items listed above, the engine is
hard to start, runs roughly, or stalls at low idle speed, it
may be necessary to adjust or service the carburetor.
Vacuum Port
Idle Speed (RPM)
Adjustment Screw