Aqua Medic DC Runner 2.2 Manual de instrucciones - Página 4
Navegue en línea o descargue pdf Manual de instrucciones para Bomba de agua Aqua Medic DC Runner 2.2. Aqua Medic DC Runner 2.2 4 páginas.
Imprimir página
Fig. 2: DC Runner 2.2 + 3.2
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure connections
9. Seal for pressure connections
Fig. 3: DC Runner 5.2 + 9.2
1. Rubber feet
2. Holding plate
3. Pump motor
4. Rear bearing
Available spare parts: Please refer to www.aqua-medic.de.
The pump may only be operated with
water depth is 1 m / 40 in.
Safety advices
The pump is constructed for indoor aquarium use only. Before working on the
6. EcoDrift Control
aquarium, the power plug must be disconnected from the mains.
The connection cable and the power plug must not be changed. If the power cable is
damaged, the pump must be scrapped.
4. DC Runner Controller
The included
DC Runner
The power can be adjusted by pressing the +/- buttons, the level is displayed by LED. If you press
the button „FEED", the output will stop for 10 minutes.
10. Adhesive sleeve D 25
11. Adhesive sleeve D 32
12. Hose connection pressure side
13. Hose connection suction side
14. Union nut pressure side
15. Union nut suction side
16. Filter basket
17. Sealing plug
5. Impeller rotor
6. Housing's sealing
7. Pump lock
8. Seal for pressure
connections
water. An installation out of water is possible. The max.
Controller is switched between power supply and pump to adjust the output.
9. Adhesive sleeve D 32
10. Hose connection
11. Union nut
12. Filter basket (only DC Runner 5.2)
7