AVPro Edge AC-EXO-444-KIT Manual de inicio rápido - Página 4

Navegue en línea o descargue pdf Manual de inicio rápido para Extensor AVPro Edge AC-EXO-444-KIT. AVPro Edge AC-EXO-444-KIT 4 páginas. 4k hdmi extender via optical fiber; up to 2 kilometer

Imprimir página
2.
From Rack (Using IR-EYE): Plug an IR-Receiver Eye into the "IR IN" of the AC-EXO-444 Trans-
mitter in order to pass infrared signals generated from a device or IR Remote. NOTE - Be sure the IR
MODE Slide Switch is set to "IR-EYE" on the Transmitter.
3.
From Remote End: Use an IR-Receiver Eye on the AC-EXO-444 Receiver (IR In Port) in order
to send IR signals BACK to the rack and out of the TRANSMITTER IR Out Port with an emitter.
Test Pattern
Once everything is connected press the pattern test
button on the receiver. A1080P 60HZ test pattern
will show on the display. Ensure the display is
turned on.
This can be useful for checking your cabling and for
troubleshooting.
Troubleshooting
Verify Power- Must power from both sides
Verify Connections - Check that all cables are properly connected
Not passing video - You can use the built in Test Pattern Generator to verify signal from the TX to the
Display
Extracted Audio Issues - Verify audio settings
IR Issues - Verify correct connections and settings
*Note: Visibly flashing Emitters may not function properly, try the IR Cables that come with the kit
If you are still having issues after troubleshooting, feel free to contact our Tech Support depart-
ment.
Have a question or need assistance?
Don't hesitate to contact us!
SUPPORT: +1 605-274-6055
USA TOLL FREE: 877-886-5112
1080P Test Pattern