Dell Equallogic PS5000xv Manual de hardware - Página 43
Navegue en línea o descargue pdf Manual de hardware para Servidor Dell Equallogic PS5000xv. Dell Equallogic PS5000xv 50 páginas. Equallogic ps series storage products
También para Dell Equallogic PS5000xv: Visión general (7 páginas)
Imprimir página
Troubleshooting
The following section describes general cluster problems you may encounter and the probable causes and solutions for
each problem.
Problem
The nodes cannot access the storage
system, or the cluster software is not
functioning with the storage system.
One of the nodes takes a long time to
join the cluster.
Or
One of the nodes fail to join the
cluster.
Attempts to connect to a cluster using
Cluster Administrator fail.
Probable Cause
The storage system is not cabled
properly to the nodes or the cabling
between the storage components is
incorrect.
One of the cables is faulty.
Volumes are not assigned to the
hosts.
The node-to-node network has failed
due to a cabling or hardware failure.
Long delays in node-to-node
communications may be normal.
One or more nodes may have the
Internet Connection Firewall enabled,
blocking Remote Procedure Call (RPC)
communications between the nodes.
•
The Cluster Service has not
been started.
•
A cluster has not been formed
on the system.
Corrective Action
Ensure that the cables are connected
properly from the node to the storage
system. For more information, see
Cabling Your Cluster for Public and
Private Networks.
Replace the faulty cable.
Verify that all volumes are assigned to
the hosts.
•
Check the network cabling
and verify that the multi-
initiator check box is
selected.
•
Ensure that the node-to-node
interconnection and the
public network are connected
to the correct NICs.
•
Verify that the nodes can
communicate with each other
by running the ping command
from each node to the other
node.
•
Try both the host name and IP
address when using the ping
command.
•
Configure the Internet
Connection Firewall to allow
communications that are
required by the Microsoft
Cluster Service (MSCS) and
the clustered applications or
services.
•
For more information, see the
article KB883398 at
support.microsoft.com.
•
Verify that the Cluster Service
is running and that a cluster
has been formed.
4
43