Dell Force10 S25P Manual - Página 30
Navegue en línea o descargue pdf Manual para Servidor Dell Force10 S25P. Dell Force10 S25P 48 páginas. Installing the s25p system
También para Dell Force10 S25P: Manual de inicio rápido (27 páginas)
Imprimir página
Step
Task (Continued)
2
If necessary, connect the RJ-45/DB-9 adapter that is shipped with the S25P system to the end of the RJ-45 cable
that will connect to your terminal.
3
Verify your terminal default settings match the default settings, as listed above, on the console port:
4
If you use the console port to download software to the switch, you will probably want to raise the console baud
rate. Establish a connection with the default settings to verify the connection. Then use the lineconfig
command to access the Line Config mode, and use the serial baudrate command to raise the baud rate on
the console port. (Match the settings in your terminal access program.)
If your system is running SFTOS, see the Getting Started chapter of the SFTOS Configuration Guide for
other console port details, such as setting the console timeout.
Installing Optics
This section contains two subsections:
•
Installing SFPs on page 31
•
Installing XFPs on page 32
The S25N and S25V each have four receptacles at the right end of their faceplates that accommodate
10/100/1000 SFP optical transceivers.
On the back of the switches, there are two bays that accept either stacking modules or 10GbE modules
(CX4 or XFP). A 10GbE module contains two ports. 10GbE modules should only be inserted or removed
when the switch is powered down, as detailed in
page 19
in
Chapter 3, Installing the
SFP and XFP transceivers can be inserted or removed while the switch is running.
Caution:
Before connecting a transceiver to a source, check the receive power of the transceiver with an
optical power meter. Generally, Force10 specified optics are not to be subjected to receive power higher
than that stipulated by the optic specification. If the optic is exposed to optical power in excess of the
specification, there is a high likelihood that it will be damaged.
Optical specifications for Force10 branded devices are at the following URL:
http://www.force10networks.com/products/mediaspecifications.asp
Force10 Networks offers various types of SFP and XFP transceivers. For details, see:
http://www.force10networks.com/products/specifications.asp
30
Inserting Optional Modules (10-Gigabit or Stacking) on
Switch.
Installing Ports