Dell PowerEdge M915 Manual - Página 16

Navegue en línea o descargue pdf Manual para Servidor Dell PowerEdge M915. Dell PowerEdge M915 25 páginas. Dell poweredge blade servers getting started guide
También para Dell PowerEdge M915: Notas de publicación (27 páginas), Manual del usuario (23 páginas), Manual de información importante (35 páginas), Manual de introducción (12 páginas), Manual de introducción (12 páginas), Manual del usuario (3 páginas), Manual de cartera (27 páginas), Manual de introducción (14 páginas), Manual de introducción (12 páginas)

Dell PowerEdge M915 Manual
Rev 1.00
Description:
Use this command to restart the module components. When this command is issued, PTM compo-
nents go through a full hardware reset, followed by software reload.
Options:
• device_number: specify a single device to reset
Example:
$ reload
3.5

Software Update Commands

3.5.1 show image ver

Synopsys:
show image ver
Description:
Display the current software image version.
ADMIN: This command also displays the firmware version of each component.
Example:
# login admin
& show image ver
Software image short version: V Z.ZZ
Software image version: X.X.XXX-<date stamp>
Component #1 firmware version: Y.Y.YYY
Component #2 firmware version: Y.Y.YYY
Component #3 firmware version: Y.Y.YYY
& login user

3.5.2 copy image from-file

Synopsys:
copy image from-file [device_number]
Description:
Update the firmware the PTM software image. In ADMIN mode, it allows selective upgrade of a
single device in the PTM. Immediately after running this command, the CLI waits for the user to
send the firmware image using the ZModem protocol. To abort this operation, use CTRL-C. For
additional details on the firmware update procedure refer to
on page 22
.
ADMIN:
16
Section 4, "Operating Procedures,"
Software User's Manual