Dell Force10 Software Defined Networking Manual de implantación - Página 23

Navegue en línea o descargue pdf Manual de implantación para Interruptor Dell Force10 Software Defined Networking. Dell Force10 Software Defined Networking 36 páginas. Z series software-defined networking (sdn) deployment guide version 1.0

Imprimir página

OpenFlow Instances

This section describes how you can use OpenFlow instances on a switch.

•

You can use up to eight OpenFlow instances on a switch; the OF ID range is 1–8.

•

Only Transmission Control Protocol (TCP) connections are supported on Dell Force10 switches. Transport Layer

Security (TLS) connections are not supported.

•

Currently, you can configure only one controller IP and one TCP port for each OF instance.

•

The connection is established when you enable the OF instance using the no shut command.

NOTE: You cannot modify the OF instance while it is enabled. To make configuration changes, you must

use the shut command on the OF instance, as shown below.

FTOS#show running-config openflow of-instance

openflow of-instance 1

controller 1 10.11.205.184

shutdown

FTOS#

•

The show openflow of-instance command displays details on the instance, as shown below:

FTOS#show openflow of-instance 1

Instance

: 1

Admin State

: Down

Interface Type

: Port

DP Id

: 00:01:00:01:e8:8b:1a:30

Forwarding Tbls : acl

Flow map

LB assist

: disabled

EchoReq interval: 15 seconds

Connect interval: 15 seconds

Number of Flows : 0

Packets (acl)

: -

Bytes (acl)

: -

Controller 1

: TCP, 10.11.205.184/6633, not-connected

Controller 2

: -

Port List

Vlan List

Vlan Mbr list

tcp