Dell Force10 Software Defined Networking Manual de implantación - Página 25

Navegue en línea o descargue pdf Manual de implantación para Interruptor Dell Force10 Software Defined Networking. Dell Force10 Software Defined Networking 36 páginas. Z series software-defined networking (sdn) deployment guide version 1.0

Imprimir página

OpenFlow Interfaces

This section describes how you can apply OpenFlow to specific interfaces.

•

You can use the S4810 and Z9000 as Hybrid switches, allowing both OpenFlow (OF) and legacy functionality

simultaneously.

•

By default, all ports are available for legacy functionality.

•

To enable OpenFlow, associate a port or VLAN to an OF instance. You can only do this when the OF instance is

disabled (in a "shut" state).

•

OpenFlow is supported with link aggregation groups (LAGs); for example, you can configure port channel

interfaces as OF ports or as members of OF VLANs.

OF Ports

The following configuration example associates two ports (Te 0/7 and Te 0/31) to of-instance 1:

FTOS(conf)#interface tengigabitethernet 0/7

FTOS(conf-if-te-0/7)#of-instance 1

FTOS(conf-if-te-0/7)#interface tengigabitethernet 0/31

FTOS(conf-if-te-0/31)#of-instance 1

FTOS(conf-if-te-0/31)#

To see the list of ports associated with an OF instance, use the show openflow of-instance command. The

number displayed in parentheses is the port ID sent to the controller (for example., Te 0/7 is sent to the controller as of-

port 8, as shown below).

FTOS#show openflow of-instance 1

Instance

: 1

Admin State

: Up

Interface Type

: Port

DP Id

: 00:01:00:01:e8:8b:1a:30

Forwarding Tbls

: acl

Flow map

LB assist

: disabled

EchoReq interval

: 15 seconds

Connect interval

: 15 seconds

Number of Flows

: 1 (acl:1)

Packets (acl)

: 0

Bytes (acl)

: 0

Controller 1

: TCP, 10.11.205.184/6633, connected (equal)

Controller 2

: -

Port List

Te 0/7 (8), Te 0/31 (32)

Vlan List

Vlan Mbr list

OF VLANs

Instead of assigning an entire port to an OF instance, you can assign a VLAN to an OF instance. You must do this when

the VLAN is created. You must enter OF VLAN members in the same way as a legacy VLAN.